Create a decorative border using the foil quill in Brother scan and cut canvas workspace Posted on 25th October 2019 *CM900 model used. 1- Open scan and cut canvas workspace. 2- Click on the shapes icon and select a square. 3- Resize to make a rectangle. 4- Select a border. You can also import a SVG to use as a border. 5- Resize the border and place over the rectangle. 6- With both the border and the rectangle selected, click weld. 7- The border will be welded to the top of the rectangle. 8- Insert the same border and flip it. Place at the bottom of the rectangle. Slightly overlapping . Click on weld. 9- Once you have your border complete, click on file, transfer FCM file via the internet. If you do not have a wireless model machine, you can transfer to a USB to place in your machine. 10- A pop up box will appear letting you know the file has transferred to your scan and cut machine. 11- Turn on your scan and cut machine. Preheat your foil quill. Click on the pattern icon. 12- Click on the transfer icon. 13- Click on the scan icon to scan your mat and material. 14- your design will now appear over your media on your mat. Click OK 15- Click on the draw icon. 16- Click on the draw icon again. 17- If the design is too fine the below window will appear. Click OK. 18- you may then need to use the cut function as a draw function. Click cut. Then click the setting tab. 19- Change the cut settings to the settings you would use to draw. 20- The machine will ask you to attach the holder, even if the holder is in place. Click OK. 21- Click the start icon. The machine will use the cut function to draw with the design as if it was using the draw function.